iHome SMARTDESIGN iC16 series Instruction Manual

Contents

iHome SMARTDESIGN iC16 series Instruction Manual Manual pdf 6 page image

3iC16 DisplayInstall Clock Backup BatteryAlarm IndicatorAudio IndicatorBattery Low IndicatorDaylight Saving TimeIndicatorSnooze IndicatorPM Indicator Time DisplayInstalling Backup BatteryThe iC16 uses a CR2032 button cell battery (included with instructions) to keepalarm and clock settings in the event of a power failure and 4 “AA” batteries tomaintain alarm operation.If the Backup Battery has been installed and a power failure occurs or the ACadaptor is accidentally disconnected, the display backlight will not remain lit, butcurrent time and alarm time settings will be temporarily maintained. Otherwise,you must reset the time and alarm settings. If 4 “AA” batteries are installed,alarm will operate when unit is not connected to AC adaptor.1. Please make sure the AC adaptor is connected. Otherwise all settings maybe lost during battery replacement.2. Open and remove the battery compartment door located on the bottom ofthe unit.3. Pinch the backup battery release tab and pull the backup battery holder free.4. Insert one CR2032 button cell battery with the + side facing upwards.5. Replace the backup battery holder into the unit, then replace the batterycompartment door.Notes:• Make sure you dispose of battery properly (see your local regulations).• Buttons will not function if only back up battery installed.• Replace the CR2032 battery when you see the Low Battery indicator flashing in the display.Pull Out Backupbattery holder