iceqube IQ27000V Operation And Installation Manual
                  | |
QD-ENG-40 REV.3 - 4 -1. The shipping container leaves the factory banded to a pallet with red arrows imprinted on the box.These red arrows should be pointing in the proper (upward) direction. The Ice Qube TMS isposition sensitive and should remain in an upright position at all times. If the Ice Qube airconditioner should arrive not banded to a pallet and not in the proper upright position with redarrows pointing upward, the shipment may have been damaged and you may wish to considercontacting the freight carrier for instructions on filing a claim.Note: Operating the unit before maintaining an upright position for 24 hours will void all warranties.2. Check for any damage to the shipping container. If the shipping container has been damaged ormarred in any way, carefully check to see if the Ice Qube TMS incurred any damage. Check forscratches, dents, rattles (which may indicate loose components), the presence of oil, and anyother irregularities. Any evidence of damage will need to be recorded on the freight bill andreported to the carrier. The freight carrier will provide instructions on filing a claim. Ice Qubecannot accept responsibility for damages that occur during shipping.PRE-INSTALLATION TEST:Before installing the Ice Qube system on the enclosure, it is recommended the unit operate for 20 to30 minutes to ensure it is functioning properly. Although the Ice Qube TMS has been tested at thefactory, internal damage may have occurred during shipping which may have not been apparentduring the unpacking inspection.1. Place the system on a solid base such as a workbench or table. Check that the weight of theunit will be supported. Be sure to allow adequate space for airflow. There are two air streamsthat must not be restricted, the cool air stream and the warm air stream.Figure 22. Check that the warm air system filter is in place, location varies with model type. See specdrawing for location.Models with the optional rain or wash down hood do not have a warm air filter and will requireregular routine condenser maintenance.3. Check the data tag for proper electrical requirements. The data tag lists the design voltage andamperage requirements of the system. Verify that the electrical supply where the system will be |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine