iceqube IQ700HE Operation And Installation Manual
                             | |
Contents
| 
9Rev. 6*Verify voltage with model*Figure 5: Power Terminal Block (optional)Operating Your SystemOnce the Ice Qube TMS has been installed onto the enclosure and the power cable has been attached to aproperly grounded electrical connection with adequate voltage and current supply, the unit is ready foroperation. As soon as electrical power is supplied to the Ice Qube TMS, both fans will begin to move airthrough the MSCCT heat exchanger.Fan Speed Controller (Ord Loc Only)Version 1.4Ice Qube offers an optional fan speed controller that requires an input voltage in the range of 24 through250 AC or DC. Check the model label for the proper voltage requirements of the heat exchanger. For eitherAC or DC voltages, (+) is positive or “hot” and (-) is negative or “neutral”, the power connection is polaritysensitive. Be careful when handling or adjusting the controller as all components and circuitry are at linevoltage except for the alarm outputs which are dry contacts.When power is applied to the heat exchanger, the fan speed controller will automatically sequence througha diagnostic procedure that will check the operation of the fans and the optional alarm relay. Following sthe test sequence.Test ModeFAN 1 comes ON. If PWM type, FAN 1 starts at minimum speed and ramps up to full speed over a 25second period with its LED blinking faster during the period. Upon achieving full speed, fan will operate atfull speed for 15 seconds. Then FAN 1 goes OFF. LED 1 pulses once per 2 seconds when the fan is off.If single speed, the fan will operate for forty seconds, LED ON when FAN is ON. Then FAN 1 goes OFF.LED 1 pulses once per 2 seconds. Pause for 3 seconds. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine