Operator ManualAspect 100-4T G3 and ISR G3L100-2843 28-MAR-2018 www.imagediagnostics.com 8• When the table is not connected to AC power, the table will automatically switch to backupbattery mode. The table should only be used under backup battery power temporarily fornecessary function if the external power supply is lost.• It is recommended that AC power be applied for a minimum of 8 hours every day to keep aproper charge on the batteries and achieve maximum battery life. Batteries are constantlybeing charged during normal use when connected to AC power.When the table is not in use and not connected to AC power, the EmergencyStop Pushbutton must be fully engaged to prevent the batteries from beingdischarged and to safely power off the equipment.• The Aspect 100-4T G3 and Aspect ISR G3 table top braking systems utilize a passive magneticbrake; it remains engaged/energized in the event of a complete loss of electrical power. Poweris necessary to release the brakes.• As the braking system utilizes permanent magnetic brakes, braking force is limited by themagnet strength. Use caution when applying pressure to the side of the table as the brakes canbe overcome if more than 70 pounds of force is applied.7.2. Preparation for Patient Use• New Installation: This equipment will need to be properly cleaned before patient use as it willinevitably come into contact with contaminants during shipping, unpacking, storage, andinstallation.• After Installation: This equipment will need to be properly cleaned between uses with patientsas it will inevitably come into contact with contaminants during procedures. Refer to section11 of this manual for cleaning instructions and approved cleaning substances.7.3. Patient LoadingCAUTIONIf the tabletop is struck hard enough, it may slideto reduce damage to the carbon fiber top.