845.2 Card supply5.2.1 Card is not supplied or 2 cards are supplied fromInput Hopper Non-standard or bad cards :Please change cards(ISO CR80 card (54mm x 86mm) must be used). Card cartridge is improperly loaded :Please properly load the card cartridge intoInput Hopper again. Card thickness of card cartridge is improperly set :Please properly adjust the card thickness control leverdepending on the thickness of card. In case card is notsupplied, please adjust the lever to the right.In case 2 cards are supplied, please adjust the leverto the left.5.3 Card jam5.3.1 Card jam in Input HopperA. Card jam in Input Hopper 1Please separate Input Hopper as Figureafter disconnecting power adaptor andcommunication cable at rear side.Figure 112 Card jam in Input Hopper 1Figure 111 Card supply problem 1
