www.jbctools.comSafetyIt is imperative to follow safety guidelines to prevent electricshock, injury, fire or explosion.- Do not use the units for any purpose other than soldering or rework. Incorrect use may cause fire.- The power cord must be plugged into approved bases. Be sure that it is properly groundedbefore use. When unplugging it, hold the plug, not the wire.- Do not work on electrically live parts.- The tool should be placed in the stand when not in use in order to activate the sleep mode.The soldering tip, the metal part of the tool and the stand may still be hot even when the station isturned off. Handle with care, including when adjusting the stand position.- Do not leave the appliance unattended when it is on.- Do not cover the ventilation grills. Heat can cause inflamable products to ignite.- Use a “non residue” classified flux and avoid contact with skin or eyes to prevent irritation.- Be careful with the fumes produced when soldering.- Keep your workplace clean and tidy. Wear appropriate protective glasses and gloves whenworking to avoid personal harm.- Utmost care must be taken with liquid tin waste which can cause burns.- This appliance can be used by children over the age of eight and also persons with reducedphysical, sensory or mental capabilities or lack of experience provided that they have been givenadequate supervision or instruction concerning use of the appliance and understand the hazardsinvolved. Children must not play with the appliance.- Maintenance must not be carried out by children unless supervised.DDE-1B 120V 50/60Hz. Input fuse: 4A. Output: 23.5VDDE-2B 230V 50/60Hz. Input fuse: 2A. Output: 23.5VDDE-9B 100V 50/60Hz. Input fuse: 5A. Output: 23.5V- Weight: 4.3 Kg (9.3 lb)- Dimensions: 148 x 120 x 232 mm- Output Peak Power: 150W per tool- Temperature Range: 90-450 °C (90-840 ºF)- Idle Temp. Stability (still air) ±1.5 ºC (±3 ºF)- Tip to ground resistance: <2 ohms- Tip to ground voltage: <2mV RMS- Ambient Operating Temperature: 10-40 ºC (50-104 ºF)- USB-A / USB-B / Peripherals connectors- RJ12 connector for RobotComplies with CE standardsESD protected housing “skin effect”Specifications14 15