kenall MEDMASTER ENVELA MRSDL4L Series Installation Instructions Manual
Contents |
www.kenall.com | P: 800-4-Kenall | F: 262-891-9701 | 10200 55th Street Kenosha, Wisconsin 53144, USAThis product complies with the Buy American Act: manufactured in the United State swith more than 50% of the component cost of US origin It may be covered by patentsfound at www.kenall.com/patents.Content of specification sheets is subject to change; please consult www.kenall.com for current product details. ©2019 Kenall Mfg. Co.1INSTALLATION INSTRUCTIONSF-4826-090418MRSDL4L / M2SRDL4L SERIESMEDMASTER ENVELA® REGRESSED DOWNLIGHTNEW CONSTRUCTION- DRYWALL CEILING – RECOMMENDED CEILING CUTOUT- 4.125" SQUAREFIGURE 1Patient Room & Surgical Suite LuminairesTHE ENVELA DOWNLIGHT CONTAINS SENSITIVE ELECTRONICS. TAKE CARE TO AVOID DAMAGE BY IMPROPER HANDLING OR STATICELECTRICITY DISCHARGE (ESD). EITHER TYPE OF DAMAGE COULD RENDER THE SYSTEM INOPERABLE OR CAUSE LATENT FAILURE.LEDNote- 28L or 28T fixtures must be installed minimum24" center to center, 12" from wall and have 1/2"clearance above the trim.1. Loosen locking screws to extend hanger bars. SeeFigure 1.2. Align bottom of hanger bar tabs to bottom of joist.3. Secure luminaire hanger bars using nails or screws.4. Position luminaire as required and lock position bytightening locking screws.5. Remove junction box cover.6. Remove appropriate 1/2" knockout(s) and connectto electrical service.7. Wire per wiring diagram using approved wireconnectors. See Figure 2.8. Replace junction box cover.LOCKING SCREWALIGN TO BOTTOM OF JOISTCOPPER GROUND WIRELEDDRIVERGREENCONNECT GROUND WIRE TO GREENAND COPPER GROUND WIRESWHITECONNECT COMMON SUPPLY WIRE TO WHITE WIREBLACKCONNECT HOT SUPPLY WIRE (120-277V) TO BLACK WIREGREYCONNECT (-)10V FROM DIMMER TO GREY WIRE (OPT)VIOLETCONNECT (+)10V FROM DIMMER TO VIOLET WIRE (OPT)FIGURE 2IMPORTANT SAFEGUARDSWhen using electrical equipment, basic safety precautionsshould always be followed, including the following:THIS PRODUCT MUST BE INSTALLED IN ACCORDANCEWITH THE APPLICABLE INSTALLATION CODE BY A PERSONFAMILIAR WITH THE CONSTRUCTION AND OPERATION OFTHE PRODUCT AND THE HAZARDS INVOLVED.CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODED’INSTALLATION PERTINENT, PAR UNE PERSONNE QUICONNAÎT BIEN LE PRODUIT ET SON FONCTIONNEMENTAINSI QUE LES RISQUES INHÉRENTS.DISCONNECT POWER TO ALL CIRCUITS BEFORE WIRING FIXTURE.INSTALL IN ACCORDANCE WITH ALL NATIONAL, STATE, ANDLOCAL CODES. DO NOT CONNECT TO AN UNGROUNDEDSUPPLY. READ ALL FIXTURE MARKINGS AND LABELS TOENSURE CORRECT INSTALLATION OF FIXTURE. SUPPLEMENTALINSTRUCTIONS MAY BE LOCATED ON THE FIXTURE, IN ADDITIONTO THIS INSTRUCTION SHEET, REGARDING ORIENTATION, ORMOUNTING RESTRICTIONS.SAVE THESE INSTRUCTIONS |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine