laguna MTSAW17536110-0130 Manual

Contents

laguna MTSAW17536110-0130 Manual Manual pdf 11 page image

10FITTING THE START /STOP SWITCHThe Switch box assembly slides onto the railslot and can be adjusted to any position to suityou, but it is suggested that it is close to theend of the aluminum rail.Once in position clamp in position bytightening the nuts.INSTALL BLADE GUARDThe blade guard assembly consists of theclear polycarbonate shield, the spreaderand anti-kickback pawls on each side.1. Disconnect saw from power!2. Remover the table insert.3. Insert the spreader into the bracket slot andtighten the lock knob shown to secure thespreader.4. Tug the spreader up to verify it is locked.5. Lift the blade guard cover just enough toslide the table insert into the table slotover the blade, then secure the insert withthe knob on the front of the insert. Theguard should swing up high enough toaccommodate the work piece.6. Lifting up the right spreader pawl, place astraightedge against the blade and thespreader.When properly aligned the spreader/rivingknife will be in the "alignment zone," shownin Fig. 3, and will be parallel with theblade.Fig. 3