lancer 2500 REMOTE series Operation Manual

Also see for 2500 REMOTE series: Installation guide Operation manual

lancer 2500 REMOTE series Operation Manual Manual pdf 14 page image

1.12 COMPLETE INSULATION BETWEEN TOWER AND PYTHONA. Check all of the tower’s syrup and water connections for leaks and repair if necessary.14!CAUTION THE PYTHON INSULATION MUST BE AIR TIGHT TO PREVENT THE FORMATION OF CONDENSATION.ALL AREAS MUST BE SEALED WITH PLASTIC TAPE AND THEN COVERED WITH INSULATION TAPE. FAILURE TOSEAL BOTH ENDS OF PYTHON WILL RESULT IN POOR PERFORMANCE FROM DISPENSER.PRECAUCIÓN EL AISLAMIENTO PYTHON, DEBERÁ SER ESTANCO AIRE PARA EVITAR LA FORMACIÓN DECONDENSACIÓN. TODAS LAS ÁREAS DEBEN SELLARSE CON CINTA DE PLÁSTICO Y LUEGO SE CUBRECON CINTA AISLANTE. NO SELLAR AMBOS EXTREMOS DE PYTHON QUE PUEDE REDUCIRSE ELRENDIMIENTO DE DISTRIBUIDOR.ATTENTION L’ISOLATION DOIT ÊTRE ÉTANCHE PYTHON AIR POUR ÉVITER LA FORMATION DESCONDENSATION. TOUS LES DOMAINES DOIVENT ÊTRE SCELLÉS AVEC DU RUBAN ADHÉSIF, PUISRECOUVERTE AVEC ISOLATION TAPE. NON SEAL DEUX EXTRÉMITÉS DE PYTHON DONNERA UNE MAUVAISEPERFORMANCE DE DISTRIBUTEUR.B. Close the python insulation which had been rolled back earlier for connection to tower manifold.Seal python insulation and tower manifold insulation with plastic tape. There should be no gapsin the insulation. The python insulation should be butted firmly against the tower manifoldinsulation and sealed in place with plastic tape.C. Follow valve manufacturer’s recommendations for adjusting water to syrup ratio (brix).2. SCHEDULED MAINTENANCE2.1 DAILYA. Remove the nozzle and diffuser from each valve and rinse well in warm water. DO NOT usesoap or detergent. This will cause foaming and off taste in finished product.B. Remove the cup rest and wash in warm soapy water.C. Pour warm soapy water into the drip tray and wipe with a clean cloth.D. With a clean cloth and warm water, wipe off all of the unit’s exterior surfaces. DO NOT USEABRASIVE SOAPS OR STRONG DETERGENTS.E. Replace the cup rest, valve diffusers, and valve nozzles.2.2 WEEKLYA. Taste each product for off tastes and/or brix changes.B. Remove the bonnet and check the level of water in the water bath. Replenish as required, andreplace the bonnet.2.3 MONTHLYA. Unplug the dispenser from power source.B. Remove the bonnet and clean the dirt from the condenser using a soft brush.C. Replace the bonnet and plug in the unit.2.4 EVERY SIX MONTHSA. Clean and sanitize the unit using the appropriate procedures outlined in Section 3 of thismanual.2.5 YEARLYA. Clean water bath interior, including evaporator coils and refrigeration components.B. Clean the entire exterior of the unit.C. Sanitize syrup lines.3. DISPENSER CLEANING AND SANITIZATION3.1 GENERAL INFORMATIONA. Lancer equipment (new or reconditioned) is shipped from the factory cleaned and sanitizedin accordance with NSF guidelines. The operator of the equipment must provide continuousmaintenance as required by this manual and/or state and local health department guidelines toensure proper operation and sanitation requirements are maintained.NOTE: The cleaning procedures provided herein pertain to the Lancer equipment identified bythis manual. If other equipment is being cleaned, follow the guidelines established by the manufacturer for that equipment.