lancer 4400 Installation Manual

Also see for 4400 Series: Operation manual Installation guide

Contents

lancer 4400 Installation Manual Manual pdf 2 page image

2Units are equipped with an automatic agitation system and will activate unexpectedly. Do not place hands or foreign objects in theice bin. Unplug the dispenser during servicing, cleaning, and sanitizing. To avoid personal injury, do not attempt to lift the dispenserwithout assistance. For heavier dispensers, use a mechanical lift.! Automatic AgitationProvide an adequate potable water supply. Water pipe connections and fixtures directly connected to a potable water supply mustbe sized, installed, and maintained according to federal, state, and local laws. The water supply line must be at least a 3/8 inches(9.525 mm) pipe with a minimum of 25 PSI (0.172 MPA) line pressure, but not exceeding a maximum of 50 PSI (0.345 MPA).Water pressure exceeding 50 PSI (0.345 MPA) must be reduced to 50 PSI (0.345 MPA) with the provided pressure regulator. Usea filter in the water line to avoid equipment damage and beverage off-taste. Check the water filter periodically, as required by localconditions. The water supply must be protected by means of an air gap, a backflow prevention device or another approved methodto comply with NSF standards. A leaking inlet water check valve will allow carbonated water to flow back through the pump when itis shut off and contaminate the water supply. Ensure the backflow prevention device complies with ASSE and localstandards. It is the responsibility of the installer to ensure compliance.! Water NoticeSPECIFICATIONSCheck the dispenser name plate label, located behind the splash plate, for the correct electrical requirements of unit. Do not pluginto a wall electrical outlet unless the current shown on the serial number plate agrees with local current available. Follow all localelectrical codes when making connections. Each dispenser must have a separate electrical circuit. Do not use extension cords withthis unit. Do not ‘gang’ together with other electrical devices on the same outlet. The keyswitch does not disable the line voltage tothe transformer primary. Always disconnect electrical power to the unit to prevent personal injury before attempting any internalmaintenance. The resettable breaker switch should not be used as a substitute for unplugging the dispenser from the power sourceto service the unit. Only qualified personnel should service internal components of electrical control housing. Make sure that allwater lines are tight and units are dry before making any electrical connections!F Electrical WarningDIMENSIONSWidth: 22.0 inches (559 mm)Depth: 30.5 inches (775 mm)Height: 39.948 inches (1014.67 mm)ELECTRICAL115 VAC / 60 Hz / 3.0 Amps230 VAC / 50 Hz / 1.5 AmpsThis unit emits a soundpressure level below 70 dBWEIGHTShipping: 185 lbs (84 kg)With Ice: 340 lbs (154.2 kg)Ice Capacity: 200 lbs (90.7 kg)Ice Dispensable: 170 lbs (77.1 kg)PLAIN WATER SUPPLYMin Flowing Pressure: 25 PSI (0.172 MPA)Max Flowing Pressure: 65 PSI (0.448 MPA)FITTINGSPlain/Carb Water Inlet: 3/8 inch barbDIMENSIONSWidth: 22.0 inches (559 mm)Depth: 30.5 inches (775 mm)Height: 35.375 inches (899 mm)ELECTRICAL115 VAC / 60 Hz / 3.0 Amps230 VAC / 50 Hz / 1.5 AmpsThis unit emits a soundpressure level below 70 dBWEIGHTShipping: 170 lbs (77 kg)With Ice: 320 lbs (145 kg)Ice Capacity: 180 lbs (82 kg)Ice Dispensable: 150 lbs (68 kg)PLAIN WATER SUPPLYMin Flowing Pressure: 25 PSI (0.172 MPA)Max Flowing Pressure: 65 PSI (0.448 MPA)FITTINGSPlain/Carb Water Inlet: 3/8 inch barbID 4400 - 22” Cubed IceID 4400N - 22” Nugget Ice