lancer CED-04 Operation Manual

Contents

lancer CED-04 Operation Manual Manual pdf 14 page image

14TROUBLE CAUSE REMEDYWater only dispensed; nosyrup; or syrup only dispensed,no water1. Water or syrup shutoff on mounting blocknot fully open.2. Improper or inadequate water or syrupflow.3. BIB supply too far from dispenser.4. CO2 pressure too low.5. Stalled or inoperative BIB pump6. Kinked line.1. Open shutoff fully.2. Remove valve from mounting block, openshutoffs slightly and check water andsyrup flow. If no flow, check dispenser forfreeze-up or other problems. Ensure BIBconnection is engaged.3. Check that BIB supply is within six (6) feetof the dispenser.4. Check the CO2 pressure to the pump man-ifold to ensure it is between 70 and 80 PSI(0.483 and 0.552 MPA).5. Check CO2 pressure and/or replace pump.6. Remove kink or replace line.No water just syrup, (Ice bankgrew to water inlet line tocarbonator tank.)1. Low water bath level.2. Unit not level.3. Syrup in water bath.4. Water cage is out of position.5. Refrigerant leak.6. Check water supply.7. Carbonator timed out.8. PCB malfunctioning.1. Add water until it flows from overflow tube.2. Level unit and add water.3. Melt ice bank. Remove all water. Refill.Locate possible syrup leak area and repair.4. Reposition water cage.5. Find leak and recharge unit. (If unit is notfrozen.)6. Turn water ON and shut unit OFF,7. Turn unit OFF then ON to reset8. See page 18.Valve will not shut off. 1. Cup lever may be sticking or binding.2. Switch not actuating freely.3. Solenoid armature not returning to bottomposition.1. Correct or replace lever.2. Check switch for free actuation.3. Replace defective armature or spring.Syrup only dispensed. Nowater, but CO2 gas dispensedwith syrup.1. Improper water flow to dispenser.2. Carbonator pump motor has timed out.3. Liquid level probe not connected properlyto PCB.4. Faulty PCB assembly.5. Faulty liquid level probe.6. Water bath frozen.7. Water line frozen.1. Check for water flow to dispenser (seeInsufficient Water Flow on previous page).2. Reset by turning the unit OFF and then3. ON (by using the ON/OFF switch on top ofthe unit or unplugging unit momentarily).4. Check connections of liquid level probe toPCB assembly.5. Replace PCB assembly.6. Replace liquid level probe.7. Thaw water bath and repair faultycomponent. (See refrigeration relatedsymptoms.)8. Refer to “Compressor starts and continuesto run until freeze and will not cut off” inTroubleshooting.