5The agitator motor will start running immediately andwill run continuously. There is a five minute delay timeron the compressor circuit. After that time, the compres-sor/condenser fan will start and run continuously untila complete ice bank is built. This will take about twohours for the 2-Valve and four hours for the 4-Valve,depending on ambient air and the supplied watertemperatures.NOTE18. Thread the power cord through the cutout in the counter orin the back of the dispenser and plug the female end of thepower cord into the outlet on the transformer box.19. Plug the other end of of the power cord into the appropriategrounded outlet.The dispenser must be properly electrically groundedto avoid serious injury or fatal electrical shock. Thepower cord has a three-prong grounded plug. If athree-hole grounded electrical outlet is not available,use an approved method to ground the unit. Follow alllocal electrical codes when making connections. Eachdispenser must have a separate electrical circuit. Donot use extension cords. Do not connect multipleelectrical devices on the same outlet. Do not unplug bypulling on the cord.! WARNINGImproper connection of the equipment-grounding conductor can result in a risk of electric shock. The conductor withinsulation having an outer surface that is green, with or without yellow strips, is the equipment grounding conductor. Ifrepair or replacement of the cord or plug is necessary, do not connect the equipment grounding conductor to a liveterminal. Check with a qualified electrician or serviceman if the grounding instructions are not completely understood,or if in doubt whether the appliance is properly grounded. Do not modify the plug provided with the appliance. If it willnot fit the outlet, have a proper outlet installed by a qualified electrician.F GROUNDING WARNINGKEYLOCK SWITCH LEGENDThe refrigeration system remains on but the door latch release solenoids are disabled. The merchandisingpanels are not lit and no product can be dispensed.The refrigeration system remains on, the door latch release solenoids are disabled, the front merchandisingpanels are lit, and product can be dispensed.The refrigeration system remains on, the door latch release solenoids are enabled, the front merchandisingpanels are lit, and product cannot dispense. Set-up and Diagnostics are performed in this position.OFFONRINSEOPERATING INSTRUCTIONS3. Turn key to RINSE mode.Product Loading/Unloading1. Thaw the Minute Pak ® in a 40°F (4.4°C) cooler for 48-72hours.2. Shake the Minute Pak®.