lancer Series 500 Operation Manual

Also see for 500 Series: Installation and service manual

Contents

lancer Series 500 Operation Manual Manual pdf 13 page image

1.10 ADJUSTING WATER FLOW (LEV®)A. The water flow can be adjusted between 1.25 oz/sec (37 ml/sec) and 2.50 oz/sec (74 ml/sec) onall dispensing valves using the followingprocedures.B. The refridgeration unit should have been runningfor at least one (1) hour before you attempt tobrix the valves. The drink temperature should beno higher than 40°F (4.4°C) when the brix isset. This is best done after the unit has made anice bank.C. Slide up ID panel until flow controls are exposed(see Figure 1)D. Remove nozzle by twisting counter clockwise andpulling down.E. Remove diffuser by pulling down.F. Install Lancer (yellow) syrup separator (PN 54-0031) in place of nozzle.G. Activate dispensing valve to fill separator syruptube.H. Hold a Lancer brix cup under the syrupseparator and dispense water and syrup into cupfor four (4) seconds. Divide number of ounces(ml) of water in cup by four (4) to determine waterflow rate per secondI. To obtain the proper flow, use a screwdriver toadjust water flow control (see Figure 1).J. Repeat process for each valve.Figure 1Typical Valve Adjustment, LEV®FLOW CONTROLWATERSODA LEVER(Optional)CUP LEVERNOZZLECOVERCOVER SCREWID PANEL(Shown inopen position)NOZZLEMANUFACTURESERIES NO.Increase DecreaseFLOW CONTROLWATERIncrease Decrease1.11 ADJUSTING WATER TO SYRUP (RATIO) BRIX (LEV®)A. Hold the Lancer brix cup under the syrup separator and activate valve. Check brix.B. To obtain the proper brix, use screwdriver to adjust syrup flow control (see Figure 1).C. Once proper ratio is obtained repeat to verify.D. Remove syrup separator (PN 54-0031 installed in Section 1.10.F above).E. Install diffuser and nozzle.F. Slide down ID panel.G. Repeat process for each valve.2. SCHEDULED MAINTENANCE2.1 DAILYA. Remove the nozzle and diffuser from each valve and rinse well in warm water. Do NOT usesoap or detergent. This will cause foaming and off taste in finished product.B. Remove the cup rest and wash in warm soapy water.C. Pour warm soapy water into the drip tray and wipe with a clean cloth.D. With a clean cloth and warm water, wipe off all of the unit’s exterior surfaces. DO NOT USEABRASIVE SOAPS OR STRONG DETERGENTS.E. Replace the cup rest, valve diffusers, and valve nozzles.2.2 WEEKLYA. Taste each product for off tastes and/or brix changes.B. Remove the bonnet and check the level of water in the water bath. Replenish as required, andreplace the bonnet.2.3 MONTHLYA. Unplug the dispenser from power source.B. Remove the bonnet and clean the dirt from the condenser using a soft brush.C. Replace the bonnet and plug in the unit.2.4 EVERY SIX MONTHSA. Clean and sanitize the unit using the appropriate procedures outlined in Section 3 of thismanual.13