We reserve the right to make changes Page 25 of 49Superuser/ Installer – SettingsGeneral settings – Language file uploadingYou can install new languages and update existing languages in the control panel.Update via USB plugGeneral settings – DisplayYou can adjust display light intensity.You can adjust interval before the display reverts to standby.General settings – Buzzer modeSwitch key beeps on or off.CP – SettingsYou can set Compact P ventilation to produce domestic hot water.Reheater type * None No heating coilWater Water heating coilAnalog Electric heating coilAllowHeat deadband *** °C Setting for regulation neutral zoneLock signal type * None No blockageHeat Heating input blockedCool Cooling input blockedFire alarm auto reset * Off Not activatedOn Allows external fire automation system access to week-ly testDeicing Deicing pause Minimum de-icing intervalOut-temp to deice (°C) At which outdoor temperature must the frost protectionsystem begin to monitor the unit?Deice max. time (min) Maximum interval for de-icing the counterflow heatexchangerEvapo-rat.deiceTime(min)Maximum interval for de-icing the evaporatorDeice fan speed (%) Extract air ventilator speed during de-icingDeice fan mode From: Fresh air ventilator OFFT6 hold time (min) Hold time at T6 defrost stop temperatureReleased: Fresh air ventilator ON (normal setting)Previous: Air intake fan runs at same setting as extractair fan during de-icingCompressor** Comp. start-start(min) States interval between compressor startsCompr.min offtime(min)States interval between compressor start and stopVFD config * Min SteuerspannungFU 1Fresh air ventilator setting at 20% airMax SteuerspannungFU 1Fresh air ventilator setting at 100 % airMin SteuerspannungFU 2Extract air ventilator setting at 20% airMax SteuerspannungFU 2Extract air ventilator setting at 100% airUsed to regulate ventilators when duct sets are not thesamePreheater settings Polar functionality Modulating pre-heating element pulses heat when ex-