nilco 431 ZRG Operating Manual
                       | |
16. Do not use the machine if the mains cable isnot in perfect condition. 2. Correct working position1. Adjusting the control handle17. When using or replacing the mains cable orextension cables, do not use types that differfrom the manufacturer's original parts.• Undo the locking device• Select the working position• Fix the locking device18. The connectors on mains and extension cablesmust be at least splash-proof. 3. Switching on/off19. The plug on the connecting cable must beinserted into a socket that accords withregulations. Danger!Only start the machine when the controlhandle is locked.20. Always disconnect the mains cable from thepower network before carrying out any cleaning,servicing or maintenance work.21. Always use suitable extension cables. 1. The built-in "dead-man's" switch prevents themachine from being switched on when thecontrol handle is vertical.22. Only connect to a power network that is fittedwith leakage current protection equipment.23. Only persons who are familiar with the machineand who have been instructed in the possiblehazards may operate, service or repair it.2. Starting the Machine:• Possible only with tilted control handle• Push the switch outwards with the indexfinger – press and hold24. Remove all jewellery when working close toelectrical components. 3. Switch off25. Only use original replacement and accessoryparts. No liability is accepted for similar partsfrom other manufacturers.• Release the switch• Machine switches off• Bring control handle into a vertical position26. When performing cleaning and servicing work,ensure that authoritative regulations applicableto the particular location regarding the correcthandling of oils, fats, acids, alkalis, fuels andother similar agents are obeyed.4. Using the MachineCaution!Take care of the mains cable27. Observe the regulations applicable to yourlocation when disposing of old machines or theircomponents.28. Do not clean the machine with a high-pressurecleaner. 1. Lightly grip the handles of the control handle inboth hands• Start machine1. Preparing the Machine • Push the control handle gently downwards= the machine runs to the leftAttaching and removing accessories.• Lift the control handle gently upwards = themachine runs to the right1. Attaching: general accessories• Unplug• Bring control handle into a vertical position5. Working Technique• Tilt machine backwards1. Begin as far away as you can from the socketor door• Fit accessory manually by turning to the left2. Work backwards2. Attaching: Smoothing accessory 3. Steadily work one track forwards and back• Place the machine on the accessory 4. Work so that the tracks overlap by about 1/3• Allow the smoothing accessory to latch intoplace turning anti-clockwise6. Fitting the spray system• Put the control handle in the workingposition 1. Undo the spray system's locking screws2. Place it on the control handle underneath thecable holder• Switch the machine on briefly3. Point the spray nozzle towards the rear3. Removal: general accessories 4. Attach the cable to the lever• Unplug 5. Tighten the locking screws• Tilt machine backwards• Remove accessory manually by turning tothe right 7. Fitting the dust extractor1. Mount the vacuum unit on the control handle4. Removal: Smoothing accessory 2. Insert the vacuum hose3. Insert cable into the control bar• Control handle in the working position4. Fit the vacuum ring• Switch the machine on briefly• Smoothing accessory becomes unlatched• Remove machine from smoothingaccessory9 |
Related manuals for nilco 431 ZRG
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine