quadral AURUM C8 User Instructions
                   | |
Contents | 
8EN 9INSTALLING1. Use the power cable supplied in the package to connect the equipment up to the mains supply.2. Check that the unit is switched off.3. Connect up the CD player to the amplifier inputs.(CD-Output) right channel = red / left channel = white4. Now switch your CD player on.Switch the mains switch (3) into the ON position on the back.The standby LED on the front will come on.7. Now press the On / Standby button (10) on the front or the button (2) on the remote control to startyour equipment.Note:As your C8 uses a special power-saving standby circuit, you can always switch on / off during normaloperation using the On / Standby button on the unit or the RC-2 remote control.Mute (button 3)Balance setting (buttons 6 & 7)Multilevel display brilliance setting (button 15)Input level setting for all inputs (button 14)Example: Input level settingUse buttons 8 (-) or 9 (+) to select the signal source and then press button 14 (Prog.) and use the volumebuttons (4 & 5) to set up the input volume to suit yourself. Press button 14 (Prog.) once again to save thesettings.AMBIENT CONDITIONSThe remote control has a range of up to 6 m and works without any problems from a radiating angle of upto 30° in relation to the front of the equipment. Dust on the transmitter or dirt on the receiving sensor andoperating it in the vicinity of fluorescent lights might reduce the range. A direct line-of-sight connectionbetween the transmitter and the receiver is needed.Notes about the removal and the correct environmentally-friendly disposal of old batteriesThe symbol shown here can be found on the equipment‘s enclosure, the packaging as well as in the doc-uments or the operating manual. It tells you that batteries provided with the equipment as well as thosesupplied with or fitted in other units must never be disposed of in household waste. They must be disposedof in an environmentally-friendly way (in compliance with the local regulations or European Directives2002/96/EU and 2006/66/EU).You should find out where the nearest collection point for electronic scrap is or where the recycling site is.Correct disposal of the equipment and the batteries will help to preserve our resources and prevent phys-ical and environmental damage. The battery (CR2032) supplied with the remote control contains lithiumand it must be disposed of in an environmentally-friendly way as described above.Proceed as described in the following section to replace or remove the battery fitted in the remote control.1. Undo the screw in the cover underneath the remote control and then remove the cover.2. Remove the battery by sliding it out of its holder.3. You must ensure that the new battery‘s polarity is correct when you fit the new one! The side of thebattery marked with (+) must point upwards so that it makes contact with the part of the holdermarked with (+).4. Refit the cover and use the screw to secure it in place. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine