sais NPW119 User Manual
              | |
Contents | 
Before Installation■ It is very important to mount the equipment in a suitable cabinet or on a stable surface.■ Make sure the place has a good ventilation, is out of direct sunlight, away from sources of excessivedust, dirt, heat, water, moisture and vibration.UnpackingThe equipment comes with the standard parts shown in package content. Check and make sure they areincluded and in good condition. If anything is missing, or damaged, contact the supplier immediately.How To Clean Your LCD Monitor4 k Caution :■ To avoid the risk of electric shock, make sure your hands are dry before unplugging your monitor from orplugging your monitor into an electrical outlet.■ When you clean your monitor, do not press down on the LCD screen. Pressing down on the screen canscratch or damage your display. Pressure damage is not covered under warranty.■ Use only cleansers made specifically for cleaning monitors and monitor screens. Cleansers not made toclean monitors and monitor screens can scratch the LCD display or strip off the finish.■ Do not spray any kind of liquid directly onto the screen or case of your monitor. Spraying liquids directlyonto the screen or case can cause damage which is not covered under warranty.■ Do not use paper towels or abrasive pads to clean your monitor. Using an abrasive pad or any wood basedpaper product such as paper towels can scratch your LCD screen.Cleaning Your MonitorTo clean your LCD safely, please follow these steps :® Disconnect the power cord.® Gently wipe the surface using a clean, dry microfiber cloth. Use as little pressure as possible.Cleaning Tough Marks and SmudgesTo remove tough marks and smudges, please follow these steps :© Disconnect the power cord.© Spray a small amount of non-abrasive cleanser on a microfiber cloth.^ ^ Caution : Do not spray or apply any liquids directly onto the monitor. Always apply the solution to your• * microfiber cloth first, not directly on the parts you are cleaning.® Gently wipe the surface. Use as little pressure as possible.® Wait until your monitor is completely dry before plugging it in and powering it up. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine