vacuubrand PC 2001 Vario Instructions For Use Manual

vacuubrand PC 2001 Vario Instructions For Use Manual Manual pdf 35 page image

page 35 of 49Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to checkcarefully the validity of this document with respect to his product. manual-no.: 999100 / 06/05/2008Interface parametersThe controller CVC 2000II is equipped with a serial interface at the rear side of the housing (RS 232C, nine-pole Sub-D-plug).☞ Respectively plug-into or remove the cable (cable RS 232C, nine-pole, Sub-D) from the interface only ifthe equipment is switched off.☞ The interface is not electrically isolated from the measuring circuit.☞ For optimal electromagnetic compatibility assemble an interface filter (cat. no.: 638235).The controller can be operated via serial interface. Measuring results, preselections and the status of thecontroller can be read at any time. Controlling via interface is only possible, if the remote operation modehas been preselected at the controller. During remote operation (”PC” is displayed) the controller canbe operated only via interface, the keys at the controller have no function, the warning triangle isdisplayed.Setting of the interfaceSetting of the interface parameters directly at the controller is described below. The factory set values areunderlined.➨ 1200, 2400, 4800 or 9600 BAUD➨ 7 data bits odd, 7 data bits even, 8 data bits none, 8 data bits odd, 8 data bits even➨ no Handshake, XON/XOFF Handshake, CTS/RTS Handshake➨ remote on, remote off☞ Unchangeable: Startbit = 1, Stopbit = 1Press key Mode ▲ during switching-on.☞ The controller switches to the mode to configurate the inter-face.BAUD-Rate is displayed.➨ Press key Mode ▲ or ▼ to select the BAUD rate and con-firm with key STOP (”96”=9600, ”48”=4800, ”24”=2400,”12”=1200).Data bits are displayed.➨ Press key Mode ▲ or ▼ to select the data bits and confirmwith key STOP.Parity is displayed.➨ Press key Mode ▲ or ▼ to select parity and confirm withkey STOP (”no” = no check of parity, ”O” = odd, ”E” = even).Handshake is displayed.➨ Press key Mode ▲ or ▼ to select handshake and confirmwith key STOP (”no” = no Handshake, ”HA” = RTS/CTS,”SO” = XON/XOFF).Remote is displayed.➨ Press key Mode ▲ or ▼ to select parity and confirm withkey STOP (”no” = local operation, ”On” = remote operation).☞ The controller switches to normal operation mode (processcontrol not active).+(mains switch)Set b.96Set d. 8Set P.noSet h.noSet r.no