wallas 30 GB Manual

Contents

wallas 30 GB Manual Manual pdf 5 page image

enInstallationHeater installationCountry specific regulations shall be followed in any installation.The warranty of boat products is valid only in boat installations. The warranty is notvalid in installations to vehicles or other spaces.The device is meant for marine pleasure craft use. The device is not designed forcontinuous use for example in live aboard boats or commercial settings. In suchuse the device will require more frequent servicing not covered by warranty.Things to note when selecting the installation locationThe device shall be installed into a dry space in a protected location. The devicemust be mounted to a solid, stable bulkhead or wall. Deck or floor mounting is notpossible with these models. When installing, please note that the device needs tobe removable for servicing. Connections and location should be made so that thedevice can be easily disconnected for removal. For maintenance, it is useful toleave 200 mm (7 7/8”) empty space below the heater for the removal of the bottomcover of the heater.The heater should be installed vertically level when the boat is on an even keel.The static inclination must not exceed 5°. While the device will tolerate beingtemporarily tilted to a steep angle (even for some hours), the burner will not yieldoptimal performance if it is constantly inclined.Select the place of installation to allow a minimum amount of bending in the warmair ducting. Avoid installing the heater and control panel in the immediate vicinity ofany potential water intrusion. If possible, install the control panel on a vertical sur-face. We recommend that the device be installed by an authorized Wallas serviceshop or installer.Things to note when installing pipes, hoses and cablesPower cables, warm-air ducting and fuel hoses must be protected in locationswhere they are susceptible to mechanical damage due to sharp edges or heat.All cables and hoses should have a fluid precluding “drip loop” to prevent water orother fluids from following wires or hoses to the heater.Installation spaceThe device can be installed within the heated space or outside of it. If locatedoutside the heated area, heating performance can be improved by installing the anintake air tube to the heated space (warm return air). If located inside the heatedarea, air refreshing performance can be improved by installing the an intake airtube to the outside air (cold, dry fresh air to be heated).The heater cannot be installed into a space which may include gasolinefumes (danger of explosion).D10081- 59 -22 GB / 30 GB490529