zBoost® Cellular REACH ZB560Y Manual10zBoost Base Unit Light IndicatorsDuring Initial Power UpLight Mode Status SolutionCycle RED,GREEN,ORANGESystem ispowering up.Please allow upto 30 seconds.N/AFlashingGREENBASE UNIT willflash GREENonce for every2 dB less thanoptimal systemgain. Threeflashes or lessindicates thesystem will stilloperate properly.1. Unplug the BASE UNIT power supply.2. Relocate the EXTERNAL ANTENNA to pick up thestrongest signal from your wireless carrier.3. Move the EXTERNAL ANTENNA as far away from theINDOOR ANTENNA as possible, with at least 15 ft. ofvertical separation (height difference).4. Plug the BASE UNIT power supply back in.5. Wait 30 secs. for the BASE UNIT to power cycle on.Solution #1After Initial Power UpLight Mode Status SolutionSOLIDGREENzBoost is ready. N/AFlashingGREENzBoost is in use. N/ASOLIDORANGEEXTERNALANTENNAand INDOORANTENNAare too closetogether.1. Unplug the BASE UNIT power supply.2. Move the EXTERNAL ANTENNA as far away from theINDOOR ANTENNA as possible, with at least 15 ft. ofvertical separation (height difference).3. Plug the BASE UNIT power supply back in.4. Wait 30 secs. for the BASE UNIT to power cycle on.Solution #2SOLID RED Signal from thecarrier’s celltower is toostrong for theBASE UNIT tooperate properly.1. Unplug the BASE UNIT power supply.2. Relocate the EXTERNAL ANTENNA to another spot.3. If you have a directional antenna re-aim it to reducecarrier signal strength.4. Plug the BASE UNIT power supply back in.5. Wait 30 secs. for the BASE UNIT to power cycle on.Solution #3FlashingREDExcessiveelectronic noisein the system –the BASE UNITwill not operate.^ Refer to Solution #2