National Instruments DAQArb 5411 manuals
DAQArb 5411
Table of contents
- user manual
- important information
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- conventions used in this manual
- About Your DAQArb 5411
- What You Need to Get Started
- Software Programming Choices
- NI-DAQ Driver Software
- Optional Equipment
- Unpacking
- Installation
- Hardware Configuration
- Figure
- ARB Connector
- SYNC Connector
- Dig Out Connector
- Signal Descriptions
- SHC50-68 50-Pin Cable Connector
- SHC50-68 68-Pin Connector Pin Assignments
- Power-Up and Reset Conditions
- DAQArb 5411 Block Diagram
- Waveform Generation
- Update Rate
- Waveform Size and Resolution
- Waveform Linking and Looping
- Waveform Staging
- Waveform Staging Block Diagram
- Direct Digital Synthesis (DDS) Mode
- DDS Building Blocks
- Frequency Resolution and Lookup Memory
- Frequency Hopping and Sweeping
- Modes of Operation
- Continuous Trigger Mode
- Stepped Trigger Mode
- Burst Trigger Mode
- Marker Output Signal
- Figure 4-16. Markers as Trigger Outputs
- Analog Output
- SYNC Output and Duty Cycle
- Output Impedance
- Output Enable
- Phase-Locked Loops
- Master/Slave Operation
- Analog Filter Correction
- Digital Pattern Generation
- Figure 4-23. Digital Pattern Generator Data Path
- RTSI Trigger Lines
- Calibration
- specifications
- bus interface
- internal clock
- Figure B-1. Analog Filter and Signal Images without Digital Filtering
- Figure B-2. Digital Filter, Analog Filter, and Signal Images with Digital Filtering
- configuration form
manualsdatabase
Your AI-powered manual search engine