Data Translation DT9847 Series manuals
DT9847 Series
Table of contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- About this Manual
- Conventions Used in this Manual
- Where To Get Help
- Chapter 1: Overview
- Hardware Features
- Key Features of the DT9847-1-1
- Key Features of the DT9847-2-2
- Key Features of the DT9847-3-1
- Supported Software
- Supported Accessories
- Getting Started Procedure
- Chapter 2: Setting Up and Installing the Module
- Unpacking
- System Requirements
- Applying Power to the Module
- Attaching Modules to the Computer
- Connecting to an Expansion Hub
- Configuring the DT9847 Series Device Driver
- Chapter 3: Wiring Signals
- Preparing to Wire Signals
- Connecting Analog Input Signals
- Connecting an Analog Output Signal
- Connecting Digital I/O Signals
- Chapter 4: Verifying the Operation of a Module
- Select the Device
- Acquire Data from an Analog Output Channel
- Configure the Analog Input Channel
- Configure the Recording Settings
- Configure the Acquisition Settings
- Start the Operation
- Chapter 5: Principles of Operation
- Analog Input Features
- IEPE Functions
- Configuration Delay
- Single-Values Operations
- Input Triggers
- Reference Trigger Sources
- Data Format and Transfer
- Analog Output Features
- Output Conversion Modes
- Continuous Analog Output Operations
- Output Trigger
- Digital I/O Features
- Triggering Acquisition on Multiple Modules
- Synchronizing Acquisition on Multiple DT9847 Series Modules
- Triggering DT9847 and DT9837 Series Modules Using the Sync Bus
- Chapter 6: Supported Device Driver Capabilities
- Data Flow and Operation Options
- Buffering
- Channels
- Ranges
- Thermocouple, RTD, and Thermistor Support
- IEPE Support
- Start Triggers
- Reference Triggers
- Clocks
- Counter/Timers
- Tachometers
- Chapter 7: Troubleshooting
- General Checklist
- Technical Support
- If Your Module Needs Factory Service
- Chapter 8: Calibration
- Using the Calibration Utility
- Calibrating the Analog Input Subsystem
- Using the Manual Calibration Procedure
- Calibrating the Analog Output Subsystem
- Analog Input Specifications
- Analog Output Specifications
- Digital I/O Specifications
- Trigger Specifications
- Master Oscillator Specifications
- Power, Physical, and Environmental Specifications
- Regulatory Specifications
- Connector Specifications
- External Power Supply Specifications
- Digital I/O and External Trigger Connector
- External USB Connector
- External Power Connector
- STP15 Screw Terminal Panel
- LED Status Indicators
- Powering the DT9847-1-1-OEM Module
- Powering the DT9847-2-2-OEM or DT9847-3-1-OEM Module
- Writing to the EEPROM Register
- Index
Related products
DT9834 SeriesDT9816 SeriesDT9850 SeriesDT3000 SeriesDT9847-1-1DT9847-2-2DT9847-3-1DT9824DT9838DT9853Data Translation categories
Measuring Instruments
Control Unit
Computer Hardware
Media Converter
PCI Card
I/O Systems
Signal Processors
Video Card
Laboratory Equipment
Motherboard
manualsdatabase
Your AI-powered manual search engine