3B RESmart CPAP User Manual
Also see for RESmart Auto-CPAP: User manual
                                    | |
Contents
| 
10 / 34RESmart®CPAP and Auto-CPAP User ManualFirst Time Setup (Patient)WARNING!Do not use the RESmart® CPAP and Auto-CPAP system until anappropriate professional adjusts the settings.Note to home care provider: Before beginning setup, be sure thatyou have available the RESmart® Setup Instructions. Clinician’s(Provider’s) Setup instructions are not included in this manual.DO NOT connect any equipment to the RESmart® CPAP or Auto-CPAP unless recommended by BMC or your health care provider.CAUTION!If the RESmart® CPAP or Auto-CPAP has been exposed to either veryhot or very cold temperatures, allow it to adjust to room temperature(approximately 2 hours) before beginning setup.Place the RESmart® CPAP or Auto-CPAP on a firm flat surfaceInstall the FilterPlace the foam filter into the filter area on the back of the RESmart®CPAP and Auto-CPAP with the blue side facing out.CAUTION! The foam filter must be in place at all times when theRESmart® CPAP and Auto-CPAP is operating.IMPORTANT! To remove AC power, disconnect the power cord fromthe electrical outlet.WARNING! Inspect the power cord often for any signs of damage.Replace a damaged cord immediately.Attach the integrated Heated HumidifierPlease see the RESmart® Integrated Heated Humidifier User Manualenclosed with your device.Connect Power CordPlug the socket end of the power cord into the AC inlet on the backof the RESmart® CPAP and Auto-CPAP. Plug the pronged end of thepower cord into an electrical outlet. System status will appear on the |
Related manuals for 3B RESmart Auto-CPAP
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine