3Com Router 5000 and Router 6000 v2.41Module Guide Chapter 1 Overview1-5Figure 1-2 Installing SICIV. Removing SICFollow these steps to remove a SIC:Step 1: Place the rear panel of the Router towards you;Step 2: Turn off the power switch of the Router and unplug the power cord;Step 3: Unplug all the network interface cables connected to the rear panel of theRouter;Step 4: Remove the captive screws on both sides of the SIC using the flat-bladescrewdriver;Step 5: Pull the SIC outward until it is completely taken out of the Router chassis.1.5.2 Installing/Removing MIMI. Tools requiredz Flat-blade screwdriverz ESD-preventive wrist strap and ESD-preventive gloveII. Installing MIMFollow these steps to install a MIM:Step 1: Place the rear panel of the Router towards you;Step 2: Turn off the power switch of the Router and unplug the power cord;Step 3: Select a slot and insert the MIM along the guides in the slot until it contacts therear panel of the Router;Step 4: Fix the MIM into the Router with captive screws;Step 5: Power on the Router, and check the LEDs of the corresponding slot on thefront panel: ON means that the MIM is operating normally and OFF means that thePOST of the MIM has failed. In the latter case, please contact your agent.
