3Com 3C16080 User Manual
Also see for 3C16080: Important information
                                              | |
Contents
| 
DUA1608-0AAA013-14 CHAPTER 3: CONFIGURING THE MANAGEMENT M ODULEThe default Trap address is 0.0.0.0, which disables Traps. Anychange to the default results in Traps being sent to the newlyspecified Trap address.To change the Trap destination, type TRA followed by a space andthe new address for the Traps. This should be the IP address ofyour Network Management Station.Use the format a.b.c.d, where a, b, c and d are numbers between0 and 255. If you type a number that is not in this range, an errormessage appears.Press [Enter] to save the new setting.Software UpgradeThe Management Module has the ability to accept a new versionof its software. If a new version is released, instructions fordownloading it to the Module will be contained in the software.The latest version of the software can be found on a 3Com bulletinboard or the World Wide Web page, details of which are inAppendix C, “Technical Support”.Exiting the Configuration ProgramFor the changes to become effective, the module must be resetusing the RESET command. You are recommended to log on to theManagement Module again to ensure that the new addresses arecorrect.Enter LO. This will return you to the login prompt. |
Related manuals for 3Com 3C16080
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine