FEDERAL COMMUNICATIONS COMMISSION RADIO ANDTELEVISION INTERFERENCE STATEMENT FOR CLASS A DEVICESThis equipment has been tested and found to comply with the limits for Class Adigital devices, pursuant to part 15 of the FCC Rules. These limits are designed toprovide reasonable protection against harmful interference in a residentialinstallation. This equipment generates, uses, and can radiate radio frequencyenergy and, if not installed and used in accordance with the instructions, may causeharmful interference to radio communications. However, there is not guaranteethat interference will not occur in a particular installation.If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on, the user isencouraged to try to correct the interference by one of the following measures:n User Instructions:n Reorient or relocate the receiving antenna.n Increase the separation between the equipment and the receiver.n Connect the equipment into an outlet on a circuit different from that to whichthe receiver is connected.n Ensure that card mounting screws, connector attachment screws and allground wires are secured and tight.n Consult the dealer or an experienced radio/TV technician for help.Changes or modifications not expressly approved by the party responsible forcompliance could void the user’s authority to operate the equipment.This product was FCC certified under test conditions that included the use ofshielded I/O cable and connectors between system components. To be in compliancewith FCC regulations, the user must use shielded cables and connectors and installthem properly.CSA StatementThis Class A digital apparatus meets all requirements of the CanadianInterference-causing Equipment Regulations.Cet appareil numèrique de la classe A respecte toutes les exigences du Réglementsur le matèriel brouilleur du Canada.VCCI Statement