46 CHAPTER 3: USING THE COMMAND LINE INTERFACECommandsThe remaining sections in this chapter describe the managementfunctions that can be carried out from the command line interface.Changing the PasswordWe recommend that setting a password is the first task you carry outon the unit. Setting a password prevents unauthorized managementaccess to the unit or stack.If you forget your password while logged out of the hub, refer to“Solving Problems With the Command Line Interface” on page 106.To set a new password or change an existing password:1 At the top-level menu, enter:system password2 You are prompted for your old password:Old password:If there is no current password, press Return without entering anytext. If you already have a password set up, then enter the password.3 The prompt changes to show:Enter new password:Enter your new password. The prompt asks you to confirm your newpassword by entering it again.The command line interface displays a message to tell you that yourpassword has successfully changed.Configuring Other System ParametersYou can display and change information about the Hub units in thestack, or the stack as a whole, using the commands on the Systemmenu.unit Moves the focus of the command lineinterface to another unit in the stack.page 50Table 5 Command Line Interface Commands (continued)Command What does it do?Describedon...
