146 APPENDIX G: COMPLETING THE ULTRA -WAN CONFIGURATION# SETDefault !4A.1 -PAth LocalDialNo = "4085551212"# SETDefault !4A.5 -PAth LocalDialNo = "4085551212"# SETDefault !4A.30 -PAth LocalDialNo = "4085555555"# Enable ConnectorSETDefault !4A -PAth ConnControl = EnableExample 3.################################################################################################################################################# ULTRAWAN CONNECTOR CONFIGURATION FILE# E1 LEASED, CHANNELIZED TEMPLATE# HOW TO CONFIGURE A SINGLE CONNECTOR# This example shows how to configure connector 4A. To configure# connectors other than 4A, substitute the connector name.# For example, to configure connector 4B, replace !4A with !4B# Connector-level path parameter configuration# The following parameter settings are only typical example settings.# Your network-specific settings need to be assigned by consulting the# connector-level path parameter documentation in the document# "Using the PathBuilder Switch"SETDefault !4A -PAth FrameMode = E1_CRC4SETDefault !4A -PAth CONNector = E1_ChannelizedSETDefault !4A -PAth LineCoding = HDB3SETDefault !4A -PAth LineDistance = SH7SETDefault !4A -PAth CLock = External# Path-level path parameter configuration# The following parameters may need to be changed from their default# settings, based on your specific environment topology:## ChannelMap: This parameter specifies the timeslots (i.e. channels)# associated with each specific path. Default setting is# no timeslots assigned so that deletions are not required.# Most likely, the timeslots mapping needs to differ from# this default setting. The sequence of commands given# below will allocate the timeslots on a one-to-one# basis with each of the 31 paths.ADD !4A.1 -PA ChannelMap 1ADD !4A.2 -PA ChannelMap 2ADD !4A.3 -PA ChannelMap 3ADD !4A.4 -PA ChannelMap 4ADD !4A.5 -PA ChannelMap 5ADD !4A.6 -PA ChannelMap 6ADD !4A.7 -PA ChannelMap 7
