3Com 3C8S5007 - SuperStack II PathBuilder S500 Switch User Manual

Contents

170 APPENDIX I: COMMANDS AND PARAMETERS FOR ULTRA -WAN CSU/DSU INTERFACESConnConFigSyntax SHow [!] -PAth ConnConfigDescription The ConnConFig parameter displays the currently configured values forall of the connector configuration parameters associated with the givenpath. Note that since this display reflects the operational state of theconnector, no parameter setting changes made since the last time theConnControl parameter has explicitly been set to “Enable” will show inthis display.A sample display is shown here:Show !3b -Path ConnConFigPath !3b FrameMode = T1_ESFPath !3b CONNector = T1_PriPath !3b SwitchType = DMS100Path !3b ENCoding = B8ZSPath !3b LineDistance = LH1-0dbPath !3b CLock = ExternalPath !3b ConnControl = EnableConnControlSyntax SETDefault ! -PAth ConnControl = ([Enabled | Disabled]SHow ! -PAth ConnCONTrolSHowDefault ! -PAth ConnControlDefault DisabledDescription The ConnControl parameter enables or disables the specified connector.ConnControl must be explicitly set to Enabled (even if the parameter iscurrently set to Enabled) to apply any connector configuration changesmade since ConnControl was last set to Enabled. A ConnControl settingof Disabled disables all paths assigned to the specified connector, andputs the transmitter in a T1 mode transmitting an AIS “all ones” signal.ConnControl, when set to Disabled, disables all paths on the specifiedconnector.ConnCouNTersSyntax SHow [!] -PAth ConnCouNTersDescription The ConnCouNTers parameter displays statistics on the T1/E1 line. Thestatistics are collected in 96 sample intervals (15 minute samples for the