3Com 5500G Getting Started Manual

Also see for 5500G SERIES: Product guide Configuration and Command Reference Guide

Contents

Installing the Linux System through an Ethernet Connection 33/ # pxe_installTry to do network install on eth1.....Get the ip address from dhcp-server.....udhcpc (v1.6.0) startedSending discover...Sending select for 10.10.10.91...Lease of 10.10.10.91 obtained, lease time 21600Get TFTP server IP address from DHCP by NextServerThe TFTP server IP address is: 10.10.10.10Get config file setup/3CR17280-72/01-00-00-12-34-56-79.....FailGet config file setup/3CR17280-72/0A0A0A5B.....FailGet config file setup/3CR17280-72/0A0A0A5.....FailGet config file setup/3CR17280-72/0A0A0A.....OKfdisk harddisk.....OKmkfs of sda1.....OKmkfs of sda2.....OKmkfs of sda3.....OKmkfs of sda5.....OKmkfs of sda6.....OKdownload vfat file(1.06/vfat.tar.gz).....OKdecompress vfat file(vfat.tar.gz).....OKdownload disk file(1.06/disk.tar.gz).....OKdecompress disk file(disk.tar.gz).....OKinstall hard disk OKinstall completed/ #3 After the installation, execute the reboot command to reboot theOSN|M:/ # rebootDo not interrupt the system while it is booting; until the followingmessages appear.Fedora Core release 6 (Zod)Kernel 2.6.18.8 on an i686localhost.localdomain login:4 Enter the username and password to log into the Linux system.A complete Linux file system is installed on the hard disk.n The first time you boot the system after an Ethernet installation, filesystem checking occurs, which consumes more time than usual. Makesure to wait until all system checking is complete before continuing.

/ 36

Related manuals for 3Com 5500G SERIES