| 
Configuring STP 7-11config stpd delete vlan[ | all]Allows you to remove one or all VLANs from an STPD. Ifall is specified, the association between the STPD andVLAN is removed, but both still exist.config stpd hellotimeAllows you to specify the time delay (in seconds)between the transmission of BPDUs from this STPD whenit is the Root Bridge.The range is 1 through 10. The default setting is 2seconds.config stpd forwarddelayAllows you to specify the time (in seconds) that the portson this STPD spend in the listening and learning stateswhen the Switch is the Root Bridge.The range is 4 through 30. The default setting is 15seconds.config stpd maxage Allows you to specify the maximum age of a BPDU in thisSTPD.The range is 6 through 40. The default setting is 20seconds.Note that the time must be greater than, or equal to2 x (Hello Time + 1) and less than, or equal to2 x (Forward Delay –1).config stpd priorityAllows you to specify the priority of the STPD. Bychanging the priority of the Switch, you can make it moreor less likely to become the Root Bridge.The range is 0–65,535. The default setting is 32,768. Asetting of 0 indicates the highest priority.config stpd port cost Allows you to specify the path cost of the port in thisSTPD.The range is 1–65,535. The Switch automatically assigns adefault path cost based on the speed of the port, asfollows:n For a 10Mbps port, the default cost is 100.n For a 100Mbps port, the default cost is 19.n For a 1000Mbps port, the default cost is 4.config stpd port priority Allows you to specify the priority of the port in this STPD.By changing the priority of the port, you can make itmore or less likely to become the Root Port.The range is 0–255. The default setting is 128. A settingof 0 indicates the lowest priority.Table 7-1 STP Configuration Commands (continued)Command Description |
