3Com AccessBuilder 980/000048/001 User Manual Manual pdf 44 page image
Manuals database logo
manualsdatabase
Your AI-powered manual search engine

3Com AccessBuilder 980/000048/001 User Manual

Page 1 previewPage 2 previewPage 3 previewPage 4 previewPage 5 previewPage 6 previewPage 7 previewPage 8 previewPage 9 previewPage 10 previewPage 11 previewPage 12 previewPage 13 previewPage 14 previewPage 15 previewPage 16 previewPage 17 previewPage 18 previewPage 19 previewPage 20 previewPage 21 previewPage 22 previewPage 23 previewPage 24 previewPage 25 previewPage 26 previewPage 27 previewPage 28 previewPage 29 previewPage 30 previewPage 31 previewPage 32 previewPage 33 previewPage 34 previewPage 35 previewPage 36 previewPage 37 previewPage 38 previewPage 39 previewPage 40 previewPage 41 previewPage 42 previewPage 43 previewPage 44 previewPage 45 previewPage 46 previewPage 47 previewPage 48 previewPage 49 previewPage 50 previewPage 51 previewPage 52 previewPage 53 previewPage 54 previewPage 55 previewPage 56 previewPage 57 previewPage 58 previewPage 59 previewPage 60 preview
Contents
  1. Table Of Contents
  2. Table Of Contents
  3. Table Of Contents
  4. how to use this guide
  5. additional safety information
  6. Introduction
  7. Principal Features
  8. Implementation of V.32terbo
  9. Typical Applications
  10. Pack Contents Checklist
  11. Pre-installation Requirements
  12. Overview
  13. Installing The Module
  14. Installing the Rear Card
  15. Installing the Front Card
  16. Connecting the Cables
  17. Front Panel LEDs
  18. Troubleshooting Guide
  19. Modem - DTE Connection
  20. Modem - Telephone Line Connection
  21. Connection Problems When Originating a Call
  22. dial backup operation
  23. Physical Description A
  24. Approvals Information A
  25. DTE Port Pin Assignments A
  26. PSTN Port Cable Pin Assignments A
  27. On-line Technical Services
  28. Access by ISDN
  29. Support from Your Network Supplier
  30. Support from 3Com
  31. Returning Products for Repair
3Com AccessBuilder 980/000048/001 User Manual Manual pdf 44 page image
A-8 APPENDIX A: MODEM SPECIFICATION AND INTER FACE PIN ASSIGNMENTSDTE Port Pin AssignmentsEach modem is equipped with a single serial port marked DTE, whichcan be used to enter asynchronous AT or V.25bis commands, and passasynchronous or synchronous user data. This is a female 26-pin V.24connector and can be used with X.21/V.11, v.24/V.28 or V.35/V.36signalling. The cable pin-outs for each type of cable are shown below.X.21/V.11The DTE port terminates with a 26-way miniature SCSI connector. The portcan be configured to support V.11 signalling characteristics. The DTE portconnecting cable is not supplied with the module. The following signallingcharacteristics should be observed when purchasing or fabricating asuitable cable.
/ 60
Related manuals for 3Com ACCESSBUILDER 7000
3Com NETBuilder II Installation Manual first page preview
3Com NETBuilder II Installation Manual
3Com SuperStack 3 4300 User Manual first page preview
3Com SuperStack 3 4300 User Manual
This manual is suitable for:
ACCESSBUILDER 7000AccessBuilder 980/000048/001
Manuals database logo
manualsdatabase
Your AI-powered manual search engine