4 SOFTWARE INSTALLATIONAND CONFIGURATIONUNDER WINDOWS 3.XThis chapter describes how to install NIC software and configurethe NIC under DOS, Windows 3.1, or Windows for Workgroups.If your PC is running Windows 95 or Windows NT, go toChapter 2 and Chapter 3.Installing NetWare Drivers for DOS, Windows 3.1, andWindows for WorkgroupsThis section describes how to use the AutoLink programto install client and driver software for DOS environmentsand Novell NetWare 3.1x or 4.1x under Windows 3.1 andWindows for Workgroups.When your system administrator configures a 3Install accounton your server, the AutoLink program logs on to the serverand updates the client software. AutoLink creates a newAUTOEXEC.BAT file and saves the old file as AUTOEXEC.3CM.AutoLink also creates a new CONFIG.SYS file and saves the oldfile as CONFIG.3CM.AutoLink RequirementsThe AutoLink program includes an installation program. To usethe AutoLink program, your PC should have only one 3C509B NICinstalled and a minimum of 1 MB of available hard disk space.Running the AutoLink Install ProgramFollow these steps to run the installation program to configurethe NIC:1 Install the NIC and connect it to the network, as describedin Chapter 1.2 Reboot to DOS.3 Insert EtherDisk diskette 2 in drive A.4 Run the installation program. At the DOS prompt, enter:a:installThe main menu is displayed, as shown in Figure 4-1.
