4-6 C HAPTER 4: S OFTWARE I NSTALLATION AND C ONFIGURATION U NDER W INDOWS 3. XThe following procedures are general. If you require more detail,see the configuration documentation that accompanied your PC.Changing NIC Configuration from ISA to EISAFollow these steps to configure the 3C509B ISA NIC for anEISA PC:1 Run the installation program as described in theprevious section.2 From the main menu of the installation program, selectConfiguration and Diagnostic Program.3 If you have more than one NIC installed, use the arrow keysto select the NIC you want to configure. Tab to the Selectbutton and press Enter.A screen identifying the NIC is displayed with the Test menu baritem highlighted.4 Use the arrow keys to select Install. The Configure NICoption is selected. Press Enter.5 When the NIC Configuration dialog box is displayed, selectModify and press Enter.The I/O Base Address field is selected. An I/O Base Address dialogbox appears.6 Use the arrow key to select EISA and press Enter.The I/O base address setting is changed.7 Select OK to save the new configuration setting andpress Enter.8 Exit the program and remove EtherDisk diskette 2 fromdrive A.9 Insert the EISA configuration utility diskette provided withyour PC in drive A.10 Turn the power off. Wait 10 seconds, and then turn thepower on.11 Follow the instructions accompanying your EISA PC to runthe EISA Configuration Program.When the program prompts you for .CFG files to copy, insertEtherDisk diskette 2, press Enter, and select the appropriate file:For the 3C509B-COMBO NIC, select: !TCM5094.CFG.For the 3C509B-TP NIC, select: !TCM5090.CFG.For the 3C509B-TPO NIC, select: !TCM5095.CFG.For the 3C509B-TPC NIC, select: !TCM5098.CFG.
