3Com Fast EtherLink XL PCI 10/100BASE-TX User Manual

Also see for Fast EtherLink XL PCI 10/100BASE-TX: Quick start guide

Contents

3Com Fast EtherLink XL PCI 10/100BASE-TX User Manual Manual pdf 57 page image

Changing PACE Configuration 5-5Changing PACE Ranges and ProtocolsYou can add information for PACE applications not listedon the PACE Applications screen. You must specify the portor socket ranges as well as the network protocol beingused. Refer to the PACE application user guide. The PACEnetwork driver uses these ranges to determine whether apacket should be treated as high-priority.1 To add the PACE ranges and protocols, click theAdditional Ranges tab.The PACE Additional Ranges screen appears.2 Enter the beginning of the port or socket range forthe application in the Range Start box.The range should be a four-digit hexadecimal value.3 Enter the Range End value of the port or socket rangefor the application.The range end should be a four-digit hexadecimal number.If only one port or socket is needed, Range End shouldmatch Range Start.4 Select the protocol that the application uses.The protocol can be TCP, UDP, or IPX. Some applicationssupport multiple protocols and have port or socket rangesfor each protocol. In this case, the range or protocol mustmatch the protocol on the PC.For example, if only TCP/IP is installed, do not enter thesocket range for IPX; otherwise, you could experience adecrease in performance.5 Once the Range Start, Range End, and Protocol areentered, click Add.The range is added to the list.To remove a range, select the range in the list andclick Remove.