3Com LS-S3610-52P-OVS Installation Manual

Contents

Installation ManualH3C S3610 Series Ethernet Switches Chapter 3 Installing the Switch3-55) Fix the other end of front mounting ears to the front brackets of the cabinet with M6screws and captive nuts and ensure that the front mounting ears and guide railshave fixed the switch in the cabinet securely, as shown in Figure 3-7.Figure 3-7 Effect diagram of front mounting ear and guide rail installation3.1.2 Mounting a Switch on a WorkbenchIn many cases, 19-inch standard cabinets are not available. Therefore, switches areoften installed on clean workbenches. To install your switch on a workbench, you simplyneed to:z Make sure that the workbench is flat and sturdy and well earthed.z Leave a clearance of 10 cm (3.94 in.) around the device for heat dissipation.z Do not lay heavy objects on the switch.3.2 Connecting the Power Cord and the Ground Wire3.2.1 Connecting the AC-Input Power CordI. AC-input power socket (recommended)You are recommended to use a monophase three-line power socket with a groundcontact or a general purpose PC power socket, making sure that the power point is wellconnected to building ground. Normally, the ground point of the power source in abuilding was buried in the ground during the construction and wiring. Still, you mustmake sure of that.