Installation ManualH3C S3610 Series Ethernet Switches Chapter 5 Loading Boot ROM and Host Software5-10Switch IP address ←(This address and the server IP address must be on the samenetwork segment)Server IP address ←(IP address of the PC that stores the file)FTP User NameFTP User PasswordStep 5: Input the FTP parameter values and press . The system displays:Are you sure to update your bootrom?Yes or No(Y/N)Step 6: Press to start file downloading and to return to the programdownloading menu. Suppose you press and then . The system startsprogram downloading and upon its completion, starts writing to Flash. After completingthe writing operation, the system displays:Loading........................................doneBootrom updating..........done!III. Loading host softwareFollow these steps to download host software:Step 1: Select <1> in the Boot Menu. The system displays:1. Set TFTP protocol parameter2. Set FTP protocol parameter3. Set XMODEM protocol parameter0. Return to boot menuEnter your choice(0-3):3Select <2>. The subsequent steps are the same as those for loading Boot ROM, exceptfor the program to be downloaded in prompt messages.5.3 Loading Software RemotelyIf your terminal is connected to the switch by a network, you can load Boot ROM andhost software remotely.5.3.1 Loading Software Remotely Using FTPRun FTP server on a local PC, provided you have configured username and passwordand have set the correct file directory. Suppose IP address of the PC is 10.10.110.1.Telnet to the switch and FTP the host program to the switch.Provided that the host program is SWITCH.app and the Boot ROM program isSWITCH.btm, you can take these steps after telnet ting to the switch.Step 1: FTP the software to the switch. ftp 10.10.110.1Trying ...Press CTRL+K to abort
