3Com NETBuilder II Installing Instruction

Also see for NETBuilder II: Installation guide Installation guide Installation guide Installation guide

Contents

3Com NETBuilder II Installing Instruction Manual pdf 16 page image

1-6 CHAPTER 1: NETBUILDER II 4-SLOT BRIDGE/ROUTER3 Verify that the configurable parameters of your device match the configurationsettings of the CONSOLE port specified in Table 1-1.4 Turn on the PC, terminal, or modem.Connectingthe Power CordA power cord is supplied with all NETBuilder II chassis. If the power cord doesnot match your requirements, contact your network supplier for assistance.The AC power switch is marked according to international I/O convention:When you press the I side, the switch is on; when you press the O side, theswitch is off.Make sure the power switch is turned off (O), and plug the power cord into theAC power receptacle on the back of the chassis.Installing the CableStrain-Relief BracketThe cable strain-relief bracket is a wire-form metal bracket. This bracket is notnecessary for systems mounted on a tabletop, but it is recommended forrack-mounted systems.To install the cable strain-relief bracket on a 4-Slot chassis, follow these steps(no tools are needed):1 Secure the bracket to the rear of the system.The ends of the bracket slide into four holes on the back of the chassis (seeFigure 1-6).Figure 1-6 Installing the Cable Strain-Relief Bracket on the 4-Slot ChassisTable 1-1 CONSOLE Port Configuration SettingsCharacteristic SettingBaud rate 9600Databits 8Parity NoneStop bits 1DTR IgnoredDuplex FullEcho OffFlow control X-on/X-off1243O IInsert ends of strain-relief bracketinto round holes on chassis.abbb Squeeze bracket together until theother ends fit into the elongatedholes on chassis.Cable strain-relief bracketaa