3Com NETBuilder II Installing Instruction

Also see for NETBuilder II: Installation guide Installation guide Installation guide Installation guide

Contents

3Com NETBuilder II Installing Instruction Manual pdf 52 page image

3-6 CHAPTER 3: NETBUILDER II 8-SLOT EXTENDED BRIDGE/ROUTERFigure 3-6 9-pin to 25-pin Modem Cable (Straight-Through-Type)2 Connect one end of the cable to the CONSOLE port on the front panel of themain processor module. Connect the other end to the serial port on the back ofyour device.3 Verify that the configurable parameters of your device match the configurationsettings of the CONSOLE port specified in Table 3-1.4 Turn on the PC, terminal, or modem.Connectingthe Power CordA power cord is supplied with your Extended chassis. If the power cord doesnot match your requirements, contact your network supplier for assistance.The AC power switch is marked according to international I/O convention:When you press the I side, the switch is on; when you press the O side, theswitch is off.Make sure the power switch is turned off (O), and plug the power cord into theAC power receptacle on the back of the unit.1 2 3 4 5 6 7 8 9 10 11 12 1314 15 16 17 18 19 20 21 22 23 24 255 4 3 2 19 8 7 625-pin male connector9-pin female connectorTo CONSOLE port To modem324857620Receive DataTransmit DataRequest to SendCarrier DetectClear to SendSignal GroundData Set ReadyData Terminal ReadyRxDTxDRTSCDCTSGNDDSRDTRTxDRxDRTSCDCTSGNDDSRDTRTransmit DataReceive DataRequest to SendCarrier DetectClear to SendSignal GroundData Set ReadyData Terminal Ready32718564Name NameAbbr AbbrPin PinTable 3-1 CONSOLE Port Configuration SettingsCharacteristic SettingBaud rate 9600Databits 8Parity NoneStop bits 1DTR IgnoredDuplex FullEcho OffFlow control X-on/X-off