3Com WX2200 - Wireless LAN Controller Hardware Installation Manual

Also see for 3CRWX120695A: User guide User guide Command reference Configuration guide Installation and Basic Configuration Guide

Contents

Connecting to the Network 413 If the cable is attached to a wired end station that uses AAA through theWX switch to access the network: For a first-time installation, set the port type to activate the link. (Forinformation, see “Setting a Port for a Wired Authentication User” inthe Wireless LAN Switch and Controller Configuration Guide.) If the port type is already set for a wired authentication port, go on tostep 4.4 If the cable is directly attached to a device other than a MAP access point:a Observe the appearance of the Link LED for the port:b If the Link LED is unlit, check the cable and verify that the device at theother end of the link is operating.MAP LED Appearance MeaningSolid green For a MAP access point’s active link, with PoE enabled,all the following are true: MAP access point has booted. MAP access point has received a validconfiguration from the WX switch. Management link with a MAP access point isoperational.For a MAP access point’s secondary link, the link ispresent.Alternating green andamberMAP access point is booting with an image receivedfrom the WX switch.Solid amber PoE is on, but no MAP access point is connected tothe link.Blinking amber MAP access point is unresponsive or there is a PoEproblem.Unlit PoE is off.Link LED Appearance MeaningSolid green 100-Mbps link is operational.Solid amber 10-Mbps link is operational.Blinking green Traffic is active on the 100-Mbps link.Blinking amber Traffic is active on the 10-Mbps link.Unlit Link is not operational.