Viewing and Changing Port Settings 187Configuring a Port fora Directly ConnectedAPA MAP access port directly connects the WX switch to a MAP. The portalso can provide power to the MAP.A Distributed MAP, which is connected to WX switches throughintermediate Layer 2 or Layer 3 networks, does not use a MAP accessport. To configure for a Distributed MAP, see “Viewing and ConfiguringMAPs” on page 281.1 Access the Create AP wizard:a Select the Configuration tool bar option.b In the Organizer panel, click the plus sign next to the WX switch.c Click the plus sign next to System.d Select Ports.e Select PoE Enabled, if you have not already done so.f In the Task List panel, select AP.2 To change the name, edit the string in the Name field. (The name cancontain up to 16 alphanumeric characters, with no spaces or tabs).3 Click Next.4 To change the model, select the model from the AP Model pull-down list.5 To change the radio type, select it from the AP Radio Type drop-downlist: 11a—802.11a 11b—802.11b only 11g—802.11b/gThe radio type is configurable on single-radio MAP models. For dual-radiomodels, the radio type is configurable on the 802.11b/g radio.6 Click Next.The non-editable number (1 or 2) indicates the radio number on the MAP.7 To enable the radio, select Enabled.8 In the Channel Number list, select the channel number for the radio.If RF Auto-Tuning for channel configuration is enabled, setting this valuehas no effect. The channel number is controlled by RF Auto-Tuning.9 In the Transmit Power box, specify the transmit power for the radio.
