Downloaded from Projector.com8 3M Multimedia Projector MP8610 3M 19984-3. Projector Power DownPress the Standby button to place the projector in the standby mode. The cooling fan motor will continueto run.9 NoteSwitching the power off before the fan has cycledoff, will decrease the life of the projection lamp.1. Wait until the cooling fan motor cycles off then press the main power switch to Off.2. Turn off the power to your input devices.3. To transport the projector, disconnect the power cord, computer cable, mouse cable and audio/videocables. Fully retract the projection lens to protect it during transport.4-4. Using System MenusYou can use the control panel buttons (Figure 3-3) or the remote control (Figure 5-1) to access menus,exit menus and set menu options. At the top of each menu is a help window, which displays messagesthat pertain to the menu item that is highlighted.Press the up/down or left/right ARROW KEYS on the control panel or move the DISC PAD on theremote to navigate through the submenus and select menu items.ÅÆ Enter for setup sub menuMenu clear menuSetupOptionAudioDataVESA 800 x 600 60 HzSync BrightnessTracking 1056 ContrastH. off. Inverse offV. off. Pix. 800x600- +HelpWindowSetupSubmenu- +- +- +- +1. Press the MENU button to display the mainmenu.2. Press the up/down ARROW KEYS or movethe DISC PAD up/down to choose a sub-menu.3. Press the ENTER button to select the sub–menu.4. Press the up/down ARROW KEYS or moveDISC PAD to select a menu item in the sub-menu.5. Press the left/right ARROW KEYS or movethe DISC PAD left/right to change the valueof a menu item.6. Press the ENTER button, if required, toconfirm the change to the menu item.9 NoteWhen the background of the displayed item turnsred, you must press the ENTER button to confirmthe change.7. Press the MENU button to exit the sub-menu and return to the main menu.8. In some cases, a message will display in thehelp window asking you to confirm thechanges made in the sub-menu. PressENTER to confirm.9. Press the MENU button to exit the mainmenu display and return to the projectedimage.