3M Multimedia Projector MP8610 Operator's Manual

Also see for Multimedia Projector MP8610: Service manual Service manual Service manual Quick setup instructions Quick start guide

3M Multimedia Projector MP8610 Operator's Manual Manual pdf 15 page image

Downloaded from Projector.com10 3M Multimedia Projector MP8610  3M 1998Section 5: Remote Control5-1. How to Operate the Remote ControlThe remote control keypad (Figure 5–3) controls basic projector functions. To use the remote control,aim the remote toward the projection screen and press the desired button. The remote signal (Figure 5-1)will bounce off of the projection screen and back to the sensor on the front of the projector.Figure 5-1. Remote Control Signal5-2. Replacing the BatteriesThe remote control uses two AAA batteries. The battery cover is located on the back of the remotecontrol (Figure 5-3).1. Press the locking tab (1) to release the battery compartment door.2. Lift up on the door (2) to remove it and set it to the side.3. Remove old batteries.4. Install new batteries (3) making sure the polarity (+/-) on each battery matches the decal in thebattery compartment.5. Replace battery compartment door.Figure 5-2. Replacing BatteriesMP86108610-12A+–+–8610-06A+–+–123