3M X90 Network Function Manual

Also see for X90: Brochure & specs Application guide Specifications Operator's guide

3M X90 Network Function Manual Manual pdf 34 page image

34Command Control via the NetworkCommand Control via the NetworkYou can configure and control the projector via the network using RS-232Ccommands.Communication PortThe following two ports are assigned for the command control.TCP #23TCP #9715Command Control SettingsConfigure the following items from a web browser when command control is used.Example: If the IP address of the projector is set to 192.168.1.10:• Command control is not available via communication port (TCP#9716) that is used for the e-SHOT transmission function.NOTE) Enter [https://192.168.1.10] into the address bar of the web browser.) Enter the Administrator ID and Password and click [Logon].3) Click [Port settings] on the main menu.4) Click the [Enable] check box to open [Network Control Port (Port: 23)] to useTCP #23. Click the [Enable] check box for the [Authentication] setting whenauthentication is required, otherwise clear the check box.5) Click the [Enable] check box to open [Network Control Port (Port: 9715)] touse TCP #9715. Click the [Enable] check box for the [Authentication] settingwhen authentication is required, otherwise clear the check box.6) Click the [Apply] button to save the settings.(9)3M™ Digital Projector X90© 3M 2007. All Rights Reserved.