Chapter 2. CLI Syntax Reference78 3ware Serial ATA RAID Controller CLI Guide/cx/px show statusThis command displays the status of the drive attached to the specified port.(Definitions of the drive statuses are available in the 3ware Serial ATA RAIDController User Guide.)Example://localhost> /c0/p5 show status/c0/p5 Status = OK/cx/px show modelThis command displays the model of the drive attached to the specified port.Example://localhost> /c0/p5 show model/c0/p5 Model = WDC WD1600BB-00DAA0/cx/px show serialThis command displays the serial number of the drive attached to thespecified port.Example://localhost> /c0/p5 show serial/c0/p5 Serial = WD-WMACK140649/cx/px show firmwareThis command displays the firmware version of the drive attached to thespecified port.Example://localhost> /c0/p5 show firmware/c0/p5 Firmware Version = 65.13G65/cx/px show identifyThis command applies only to 9550SX, 9590SE, and 9650SE modelcontrollers that have chassis control hardware (enclosure services) attached.This command shows whether the LED of the drive attached to the specifiedport is set to on or off. For details, see “/cx/px set identify=on|off” on page 81.Example://localhost> /c0/p5 show identify/c0/p5 Identify Status = on
