4IPNET EAP210 User Manual
Also see for EAP210: Quick installation guideQuick installation guideUser manual
                                                                                                                                                                      | |
Contents
| 
User’s ManualEnterprise Access Point ENGLISHCopyright © 4IPNET, INC. All rights reserved. 1167.4.2 Backup & RestoreThis function is used to backup and restore the Access Point’s settings. The AP can also be restored tofactory default using this function. It can be used to duplicate settings to other access points (backupsettings of this system and then restore on another AP).Backup & Restore Page Reset to Default: Click Reset to load the factory default settings of the Access Point. A pop-up Page will appear to re-confirm the request to reboot the system. Click OK to proceed, or click Cancel to cancel the rebootrequest.Reboot Confirmation Prompt A warning message as displayed below will appear during the reboot period. The system powermust be kept on before the completion of the reboot process. The System Overview page will appear upon reboot completion.Additionally, there are two ways to reset the system to factory default settings from the consoleinterface:1) COM Port connection - Should the administrator forget the AP’s IP address, with the right baudrate and a termination simulation program such as PuTTy or Hyper Terminal, a login promptshould be seen as such: |
Related manuals for 4IPNET EAP210
manualsdatabase
Your AI-powered manual search engine