AAF PulsePak Prime 2-1H Installation, Operation And Maintanance Manual
                                      | |
Contents
| 
17 PulsePak Prime GDED-IOM-216-B9.2.2 Flanged jointsFlanged joints exist where housing modules must be bolted together andwhere accessories are bolted to the outer faces of the housing. In all cases, AAF willprovide sufficient tubes of sealant which must be applied to one of the opposingfaces just prior to the faces being brought together. When applying sealant becareful to circle each bolt hole with the sealant. See also 9.2.4.9.2.3 Products shipped as a single assemblyAll units will be shipped upright with shipping legs installed. Careful lifting,using the supplied lifting lugs, is required to lift the unit prior to lowering the unitonto the pre-prepared foundation.9.2.4 Products shipped in multiple modular assembliesWhere product is shipped with the main housings in multiple modularassemblies, with the legs separate, proceed as follows:Follow item 9.2.4.1 to pre-install the legs and then bring in the housingmodules, in turn bolting the first to its legs before bringing in the second.Pre-apply the sealant to the flanges as 9.2.2 and then bolt the housingstogether.Install all the supplied bolts between housings loosely at first. Access to thebolt holes is gained via the porthole covers and the inlet/outlet openings (removethe covers). When all the bolts are loosely in position they must be tightened in asequence working from the center bolts towards the corners, radiating outwards inopposite side in sequence so that the four corner bolts are last to be tightened. Thispulls the modules together with all the mating flanges flat against each other withno bulges.9.2.4.1 Leg structureAssemble the leg structure onto the prepared foundations or steelwork usingthe supplied GA drawing which shows the position of all the legs and cross braces.Ensure all the nuts and bolts are tightened and the structure is mechanically soundand secure, and level before proceeding to the next stage.Anchors must comply with local code requirements and must be capable ofsupporting dead, live, wind, seismic, and other applicable loads for the area the dustcollector is going to be installed. |
Related manuals for AAF PulsePak Prime 10-2H
AAF FabriPulse BinVent Installation, Operation And Maintenance Manual
AAF TM4 Installation, Operation And Maintanance Instructions
AAF FAH-202-2P-MD Installation, Operation And Maintenance Instructions
AAF SAAF PORTA-Scrubber PS-200 Installation, Operation And Maintenance Instructions
AAF Astrocel I HTP User Manual
This manual is suitable for:
PulsePak Prime 10-2HPulsePak Prime 12-3HPulsePak Prime 15-3HPulsePak Prime 16-2HPulsePak Prime 18-3HPulsePak Prime 2-1HPulsePak Prime 20-2HPulsePak Prime 24-2HPulsePak Prime 24-3HPulsePak Prime 27-3HPulsePak Prime 28-2HPulsePak Prime 3-1HPulsePak Prime 30-3HPulsePak Prime 33-3HPulsePak Prime 36-3HPulsePak Prime 4-1HPulsePak Prime 42-3HPulsePak Prime 45-3HPulsePak Prime 6-2HPulsePak Prime 8-2HPulsePak Prime 9-3H
manualsdatabase
Your AI-powered manual search engine