AAVIK U-150 User Manual
            | |
Remote functionsPage 11A ABCDEFGDFCGBVOLUME UPPress this button to increase the volume setting.VOLUME DOWNPress this button to decrease the volume setting.INPUT +Press this button, to move to the next input. From Line 1 to Line 2 etc.INPUT -Press this button, to move to the previous input. From Line 2 to Line 1 etc.STANDBYPress this button to place the amplifier in standby mode, or to switch the amplifieron from standby mode.MENUUse this button to enter the menu, or switch back to normal operation. Use theINPUT + and INPUT - buttons to cycle through the menu, and the VOLUME UPand VOLUME DOWN buttons to change a setting. See “MENU FUNCTIONS” fordetails.MUTEPress the button to mute the outputs of the amplifier. A small light beneath themute button of the front panel will indicate that the outputs of the amplifier aremuted. Pressing the button again will reactivate the outputs of the amplifier.FACTORY RESETYou can reset all settings back to factorydefaults. This will erase off-set settings,the cartridge load setting, the balancesetting, the DAC settings and the remotepairing settings. To do this, proceed asfollows:• Switch off the amplifier at the mainpower switch (Page 4, 4)• Wait 30 seconds• Press and hold the three front panelbuttons (Page 8, 13, 14, 15)• Switch on the main power using(Page 4, 4), while still holding the frontpanel buttons• All LED indicators on the front panelwill switch on, and stay on• After approx. 8 seconds theLED indicators will switch off again.• Release the front panel buttons, andswitch off the amplifier using the mainpower switch (Page 4, 4)E |
Related manuals for AAVIK U-150
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine