ABB ACH400 Series Retrofit Manual

Also see for ACH550 series: Installation manual User manual User manual User manual Installation supplement

Contents

ABB ACH400 Series Retrofit Manual Manual pdf 11 page image

11Step 14: Clean up the installation area. Perform any general cleanup necessary. Use a brush, vacuum andother equipment to remove any dust and debris from the bypassunit, frame work and other areas.Step 15: Prepare the new ACH550 for installation. Remove the ACH550 from its packaging.A separate internal package may contain a conduit box and will notbe used for this installation Remove the control panel and set aside for future steps. Using a Phillips head screw driver, loosen the captive, gold-coloredcover screw and lift the cover from the drive.Step 16: Mount the new ACH550.R1 and R2 Frame Sizes: Mount the ACH550 into the mounting channel by hooking the bot-tom mounting slots over the screws and then tilting the top back tothe channel. Reinstall the top two mounting screws through the drive mountingfeet. Slide the drive down as far as it will go. After all 4 screws are in place, tighten the top and bottom mountingscrews.