Installation checklist of the driveContents of this chapterThis chapter contains a checklist of the mechanical and electrical installation of the drive.ChecklistExamine the mechanical and electrical installation of the drive before start-up. Go throughthe checklist together with another person.WARNING!Obey the safety instructions of the drive. If you ignore them, injury or death, ordamage to the equipment can occur.If you are not a qualified electrician, do not do installation or maintenance work.WARNING!Stop the drive and do the steps in section Electrical safety precautions (page 144)before you start the work.Make sure that …The ambient operating conditions meet the drive ambient conditions specification, and enclosure rating(IP code or UL enclosure type).The supply voltage matches the nominal input voltage of the drive. See the type designation label.The drive cabinet has been attached to floor, and if necessary due to vibration etc, also by its top tothe wall or roof.The cooling air flows freely in and out of the drive. Air recirculation inside the cabinet is not be possible(air baffle plates are on place, or there is another air guiding solution).If the drive is connected to a network other than a symetrically grounded TN-S system: Check thecompatibility. See the electrical installation instructions in the supply unit manual.6Installation checklist of the drive 167
